Challenge Paper Drill Sharpener with 3-Flute Reamer
Double-tap and hold to zoom.
Mouse over the image to zoom.

Challenge Paper Drill Sharpener with 3-Flute Reamer

Part Number: CSHARP

Our Challenge hand-held drill sharpener includes a 3-flute carbide reamer

Checkmark Icon

Twisting action sharpens drill bits in seconds

Checkmark Icon

Accepts Challenge drill bits ranging from 1/8" to 9/16" diameter

$172.25 /EACH
List price: $172.25 /EACH
    • EACH
  • Availability: In stock

Instructions

1) Carefully place a hollow drill bit in the holder section of the sharpener.

2) Make sure the reamer set screw is tightened, so that it doesn't spin during sharpening.

3) Insert the holder section back into the sharpener end, being careful not to bump the drill bit into the sharpening reamer to avoid chipping.

4) Rotate clockwise while maintaining even pressure on the drill bit and sharpening reamer.

5) Turn by hand until the drill bit is sharpened, usually just a few turns.

6) Remove the drill bit from the holder section by bumping the base of the drill bit on a flat surface to pop it out.

7) Return the drill bit to service. If the drill bit remains too dull, repeat the above steps.

You May Also Be Interested In

Single-Flute Carbide Reamer with 3/8" Shank
  • $47.00 /EACH
  • List price $47.00 /EACH
  • EACH
  • Availability: In stock
Paper Drill Bit Burr Removal Stone - 4" x 1" x 1/4"
  • $18.85 /EACH
  • List price $18.85 /EACH
  • EACH
  • Availability: In stock
Drill-Ease Lubrication Stick
1x $3.25
12x $2.95
List price $3.25 /EACH
  • EACH
  • Availability: In stock
3-Flute Carbide Reamer with 3/8" Shank
  • $111.70 /EACH
  • List price $111.70 /EACH
  • EACH
  • Availability: In stock